Category: Electrical / Plumbing

Installation of the conduit and wires for the landing, taxi and navigation lights.
Continue reading “Electrical conduit and wires right wing”

With help of a multicore cable tester I identified and checked all wires in the left wing for the nav, landing and taxi lights. Next I marked them with Dymo heat shrink tubes.
Continue reading “Wires checked and labeled”

Garmin replaced my pitot tube because it did not pass the leak test; great service from Garmin! So I could redo the installation.
Continue reading “New pitot tube”

I fixed the leak at the flare, moved to Nyloseal and did another leak test with a digital meter.
Continue reading “Pitot installation fix and new leak test”

Spread over the last days I did some leak testing of the pitot tube.
Continue reading “Leak test pitot tube”

I received the 3D-printed spacer and continued with the installation of the pitot.
Continue reading “Pitot tube installation part 2”

I prepared for the pitot installation.
Continue reading “Pitot tube installation part 1”

Now that the wires for the lights are ready I started with the wires and plumbing of the heated Garmin pitot.
Continue reading “Pitot tubes and wires”

After all the brackets were dry I could start installing the conduit and wires.
Continue reading “Conduit left wing”

Another bracket was needed to transform from the 16 mm conduit to the 13 mm conduit.
Continue reading “Conduit brackets 2”