Since I don’t have the holes in the side skins for the main spar carry through I have to be 100% that the fuselage is aligned correctly before drilling these holes.
Continue reading “Fuselage alignment”
Category: 30 – Fuselage
Main gear shim 1
According specification the main gear should fit in landing gear channel with a gap of maximum 0.5 mm, otherwise a shim is needed.
Continue reading “Main gear shim 1”
New CF side skins
Because my main spars are a bit thicker the holes in de side skins didn’t line up perfectly. I received new side skins without these holes.
Continue reading “New CF side skins”
Strengthen console skins
The console skins are still a bit flimsy. Normally they are attached to the parachute-box, but since I’m building without a parachute, some strengthening is required.
Continue reading “Strengthen console skins”
Rivet arch skin
Finally it’s time to rivet the arch skin and close the RF.
Continue reading “Rivet arch skin”
Interior lights backing plates
For the interior lights there are eight 3 mm holes, but so close to the edge that no rivnuts could fit in, for that I made a backing plate.
Continue reading “Interior lights backing plates”
Minor tweaks arch skin
Some more minor tweaks were needed before the arch skin could be riveted.
Continue reading “Minor tweaks arch skin”
Rivet RF middle top skin
After all preparations, installing the RF middle top skin was an easy job.
Continue reading “Rivet RF middle top skin”
Arch skin fixes
The arch skin is a tight fit and fitted nicely, however some fixes were needed for a better result.
Continue reading “Arch skin fixes”
Com antenna plate
The com antenna plate was not as easy as it looked like and took much more time than I thought.
Continue reading “Com antenna plate”