Hrs: 9

Replace right angle 25 and 4

The same procedure as on the left side now on the right side to replace angle 25 and angle 4.

Removing the rivets is a bit difficult but went without any damage to the existing holes:

A chamfer was sanded to prevent a conflict with the rear angle:

There was a 1.5 mm gap between the outside of the angle and the firewall strip, this would we be visible when the skin will be installed:

The angle was modified:

Perfect now:

After machining the doubler and priming all parts it was time to shoot the rivets:

New angles in place:

Detail of the doubler: