Preparing the top skin for paint and designing and fabricating the doublers.
Continue reading “RF top skin and doublers”
Month: June 2023
New RF top skin
A while ago I received a new RF rear top skin without holes in the areas where I had serious misalignment. Time to drill some holes…
Continue reading “New RF top skin”
“First flight”
While waiting for new CF skins I will continue to work on the RF, for that the fuselage must be lowered.
Continue reading ““First flight””
Test fit both side skins
The left outside skin was already modified and good-to-go for another test-fit, the right skin needed some fixes before being test fitted.
Continue reading “Test fit both side skins”
Rivet inside forward skins
The forward part of the cockpit is painted dark grey. The forward skins need to be installed and those rivets should be painted dark grey as well. Since the firewall is still removable this is a good time to install the forward inside skins and paint those rivets.
Continue reading “Rivet inside forward skins”
Paint firewall / inside rear skins and clean paint booth
What I thought would be an easy quick paint job became a lot more work.
Continue reading “Paint firewall / inside rear skins and clean paint booth”
Firewall work
Before the outside skins can go on the firewall must be in place, time to test-fit the firewall and related parts.
Continue reading “Firewall work”
Check SB0023
3 SB’s were released, two for the Rotax engine and one for the nose gear, since I don’t have the engine yet I could only verify SB0023.
Continue reading “Check SB0023”
Fixes for outside CF skins + handle 2/3
More work on the outside skins.
Continue reading “Fixes for outside CF skins + handle 2/3”
Wing spar spacers
Last couple of days I worked on wooden wing spar spacers.
Continue reading “Wing spar spacers”