Some small fixes were still on the todo list which required some touching up of the primer, furthermore the custom created and replacement parts needed some primer as well.
Fix 1, removing some material from the flanges to prevent the seatbelt bracket is touching the flange of the console rib as described here:
Fix 2, removing some material from the parts of the rear spar assembly, as described here:
After priming:
The new seatbelts brackets have the correct length now however they have not the same width. No problem however I think:
I left the location for the transponder antenna studs blank aluminium to the studs can make good ground contact:
Multiple parts primed and curing:
