All parts of the rear spar assembly are ready to be assembled, but some issues here…
Continue reading “Start with rear spar assembly”
Month: April 2022
Start assembling rib 1 + 2 + console rib
The primer was cured so I could rivet the 6 ribs, but this step could not be finished due to 2 issues.
Continue reading “Start assembling rib 1 + 2 + console rib”
Prepared rear spar section parts
Deburring and priming the parts of the rear spar section.
Continue reading “Prepared rear spar section parts”
Prepare ribs connecting to main gear assembly
Deburr and prime of rib 001 assembly, rib 002 assembly and console rib assembly. These parts all connect to the main gear assembly.
Continue reading “Prepare ribs connecting to main gear assembly”
Main gear mounting frame finished
During the test fit I noticed a couple of things that needed some attention.
Continue reading “Main gear mounting frame finished”
Main gear mounting frame prime and test fit
Time to start working on the center fuselage, first section is the main gear mounting frame.
Continue reading “Main gear mounting frame prime and test fit”
RF lower skins test-fit / hole misalignment
Time to test-fit the RF skins, the left skin fits without any issues but unfortunately the 4 mm holes of the right skin don’t align.
Continue reading “RF lower skins test-fit / hole misalignment”
Shoulder harness attachments 2
After a long time, working on other projects, I’m back on the Sling project. First thing is measuring the shoulder harness assemblies length as requested by Sling Aircraft.
Continue reading “Shoulder harness attachments 2”