Continued with putting the elevator together with cleco’s.
Continue reading “Continue with temporary fit of elevator parts”
Month: October 2016
Start of elevator
Studying and start of elevator.
Continue reading “Start of elevator”
Rivet horizontal stabiliser
The primer is dry so I started riveting the parts of the horizontal stabiliser and fitted the skins with cleco’s. Continue reading “Rivet horizontal stabiliser”
Rivet rudder parts
First cleco and then rivet the parts of the rudder. Continue reading “Rivet rudder parts”
Deburred and primed horizontal stabiliser
Deburred, cleaned and primed the parts of the horizontal stabiliser
Continue reading “Deburred and primed horizontal stabiliser”
Temporary fit the horizontal stabliliser
While the parts of the rudder were drying I could start on the horizontal stabiliser.
Continue reading “Temporary fit the horizontal stabliliser”
Deburred and primed rudder
Removing the cleco’s, deburring, cleaning and priming the parts of the rudder.
Continue reading “Deburred and primed rudder”
More lights and full face respirator
When priming the vertical stabiliser the light conditions were not ideal, also the half face respirator was not ideal.
Continue reading “More lights and full face respirator”
Rudder parts adjustments
Some parts of the rudder didn’t fit 100%, especially when the skin was attached with cleco’s.
Continue reading “Rudder parts adjustments”
Temporary fit the rudder
Next part is the rudder, first mounted all parts with clecos.
Continue reading “Temporary fit the rudder”